FAQ

O2Nails Italia nail printers work with the O2Nails app, available for smartphones and tablets with iOS and Android operating systems. After downloading the app, connect to the printer via Wi-Fi, select the image you want to print from your gallery or from your device, and proceed to print by following the steps. The process is very simple; watch the demonstration video by clicking the following link: https://youtu.be/tjBov_Clz-c

To print, apply PG0 (clear) or PG4 (white) printing primer to your natural nail or nail tip, insert your finger into the front slot of the printer, and print the image you previously selected from the app. Printing takes approximately 30 seconds. Once printing is complete, remove your finger and cure under an LED lamp for 60 seconds. Then apply a layer of TG Top Gel and cure again under an LED lamp for another 60 seconds. At this point, the process is complete. Watch the demonstration video by clicking the following link:  https://youtu.be/tjBov_Clz-c

To print you need 4 products:

PG0 - It is a transparent printing primer, it is used to print images in PNG format on the previously colored nail without a background so that the underlying coloring remains as a background.

PG4 - It is a white print primer, used as a background for printing full color images. 

TOP GEL - It is the finishing gel that gives shine to the print and protects it over time.

NAIL MASK - It is applied to the skin around the nail so that the print does not imprint the skin, it is removed once the print is finished.

The M1 and H1 printer models use the FM10 print cartridge, which can perform approximately 200 prints. The V11, F1, X11, X11 PLUS, and X12.5 printer models use the SM10 print cartridge, which can perform approximately 500 prints.

The print is permanent and lasts as long as the nail grows. If you want to remove it, you'll need to use a drill. If you print on a nail tip, the print can last several years.